Share this item
commented on "Series Aliens"
on www.dtlcoils.co.nz
http://www.dtlcoils.co.nz/gallery/Uncategorised/series-aliens/505147
The Alien coil consists of 3 pieces of round wire wrapped with a thinner, wavy "alien" fuse wire.
This build has one of the best wicking capabilities out of all the types of coils out there. It stays clean for longer than your traditional coil with plain round wire or a straight fused outer wrap. Crowd favorite!
Due to the size of these coils, you will need a large atomiser to use them. At a minimum, a Goon or similar sized deck is required.
Designed for fully mechanical series mods (not recommended for MOSFET switches), or regulated devices.
28G N80/38G N80 | 3mm | 9wraps | 0.25-0.29Ω (average resistance 0.27Ω)
•Included in each order will be a set of TWO coils
•These coils are thoroughly cleaned and sterilised before packaging/shipping.
•Resistance on each coil can vary +/- depending on lead lengths and/or what atomiser you install them in.
•Entirely handmade by David Lawes
*ATTENTION* These coils are made from resistance wires, and can be dangerous if used incorrectly. Please be aware of battery safety and Ohm's law before purchasing and using these coils. They are for experienced users ages 18+.
Item added 14 December 2018